How to correctly use monofilament butt Welding Machine A welding: 1. straightening the ends of the wire so that they pipe, ensure that the current through it. Adjust pointer
2.left hand, adjust the welding wire diameter or cross-sectional area.
3.adjust the appropriate connector. 4.the right hand lever is moved forward to the end. 5.when dealing with large stiff wire, steel wire bent into a circle of right hand side so that top bar moves freely and not under the influence of pressure the wire itself. 6.Groove in the jaw clamping wire ready ends, intermediate between both ends of the wire closing jaws, the best approach is to clamp the left hand Side of the wire, and then clamped his right hand side wire. Both ends of the wire must be on one line, if there is a need to further straightening of working 7.fine steel wire welded machine body, move the clamping lever clamping wire down. In coarse-wire welding machine, clamping lever must be pulled forward, clamping lever must be pulled, to rest. 8.after the wire clamp, welding right hand move the joystick to the back action automatically. 9.adequate time must be allowed after welding cooling, the right hand lever moves slowly forward until it encounters significant resistance,
10.release the wire.
11. the right hand lever moves forward again to the head. B, post weld heating (annealing) If the wire is hard wired must be annealed to guarantee correct transition of the wires to the heating effect of welding and annealing on the high c wires are particularly important, welding tumor must be removed first, this way, the temperature uniformity of steel wire, wire welding must be tempered. 1. in annealed attachment clamp on a wire. 2. turn on annealing power, by annealing switch. 3. annealing device with variable length%
Mr. Liu Bin
June 13, 2018
